3 remove the rollers.
Take sliding door off track.
Even if you have brackets on the bottom of your door they re probably just connected to your wheels.
How to repair sliding door rollers 1 unscrew the rollers from the bottom edge of the door.
If your sliding glass doors don t have the screen door then you may move on to the next step.
Slip a flat screwdriver underneath the wheels and push them upwards.
2 pull out the rollers and the weatherstripping gasket.
In this photo you can see the large round screw head that is.
Moving the door when the back side is sliding on the ground is a little difficult.
Sliding patio doors have two separate units namely the sliding door panel and the stationary panel.
Kung fu maintenance demonstrates how to replace some wheels that are not rolling right on a patio slider door that is coming out of it s track and not rollin.
Once secure release the door.
Slide the door over.
Remove the door from the track.
Insert the screwdriver at the bottom to lift the rollers from the track.
You will be able to tell the wheels are sufficiently.
Dirt mud hair and fur can collect along the track and in the groove which clogs the rollers underneath and prevents smooth motion.
Work the door slowly into the opening in this manner.
Wiggle the door until the pivot snaps into the hole.
Pull the door up from the bottom track until the wheels are out.
Bring the door to within a few inches of the strike side jamb.
Pushing the wheels up will make it easier to.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
Hold down the spring loaded guide on the opposite side of the other door panel and swing the door until the guide is under the track.
Find the adjustment screw and rotate it with a screwdriver phillips or slotted depending on model to bring.
In order to remove the sliding one effectively lift it upwards into the upper track and ask a helper to push the bottom gently and carefully toward you.
To remove the screen door use a flathead screwdriver.
Taking the door out of the track 1.
Once the door is approximately under the hole in the track release the pivot.
Loosen every single screw to ensure that you don t miss one and crack your.
Loosen the screws at the top of both doors.
According to this old house debris build up is the main reason for a sliding door that refuses to glide.
Note that the rollers of the door shown here reside up inside a.
Here s how you can clean the rollers and the track.
Look at the bottom of each closet door to locate wheels that rest on the bottom track.