Posted on feb 06 2010.
Suzuki door handle access switch not unlocking door.
Front driver and passenger side interior door handle black.
My driver side door just stopped locking and unlocking when using the remote.
The remote will open and lock the other doors.
Again check the unlock button for a poor wiring connection a dirty switch or any other sort of obvious damage.
Chances are the switch is simply not allowing enough voltage through to actually unlock the doors.
Push the power door locking switch of the driver s door to the lock position.
My car has an automatic transmission.
Your problem is with the right front door lock actuator failing the door latch assembly will probably have to be replaced.
The central power locking system of my 2007 suzuki sx4 seem to be malfunction.
Within 5 seconds of driver s door locking unlocking press remote control lock button fig.
1 the remote key could not lock or unlock all the door lock.
Hi all need help.
Suzuki interior door handle customer reviews.
On the forenza it has two wire connections attached to the switch one for routing power to it and one for the power.
You do not need to pull and hold the door handle as you close the door.
Front or rear driver side interior door handle gray.
Push the power door locking switch of the driver s door to the lock position and then push it to the unlock position.
Repeat step 4 three more times.
Purchased on aug 30 2020.
3 both the driver side s and front passenger side s power locking switch at the doors next to the power window switch.
10 12 crosstour 07 12 cr v 09 12 pilot with non power tailgate.
Power door locking system.
1 1 or unlock button 2.
You can lock and unlock all the doors including the tailgate of sx4 simultaneously by.
2 using the key to turn at the doors could only lock and unlock that door.
Confirm programming has been successful by locking and unlocking vehicle.
My car has 67000 miles.
I have a 2007 suzuki reno basically same as forenza mechanically which had same door lock problem.
For an interior door that has a small hole in the handle you can use a small screwdriver to unlock it.
Just insert the screwdriver into the small hole and press the button on the inside of the handle with it to unlock the door.
When this issue occurs it s.
Could not open any of the 4.
Remove the key from the ignition switch and then insert it again.
Repeat step 1 two more times.
If nothing seems to be wrong it is a good time to do electrical testing while you have access.
Turning the key in a front door lock or pushing the power door locking switch located on the driver s side or the front passenger s side door panel.
A maximum of 2 remote controls can be programmed.
There is a master door lock switch box connected to the front driver side door latch inside the door panel.
